TP-Link TL-R600VPN Configuration Manual page 18

Configuring Network
Static IP: If your ISP provides you with a fixed IP address and the corresponding
parameters, choose Static IP.
Dynamic IP: If your ISP automatically assigns the IP address and the corresponding
parameters, choose Dynamic IP.
PPPoE: If your ISP provides you with a PPPoE account, choose PPPoE.
L2TP: If your ISP provides you with an L2TP account, choose L2TP.
PPTP: If your ISP provides you with a PPTP account, choose PPTP.
BigPond Cable: If your ISP provides you with a BigPond Cable account, choose BigPond
Cable. BigPond Cable is only available for Australian users.
 Configuring the Dynamic IP
Choose the menu Network > WAN > WAN to load the following page.
Figure 2-2 Configuring the Dynamic IP
In the Connection Configuration section, select the connection type as Dynamic IP. Enter
the corresponding parameters and click Save.
Connection Type
Host Name
Upstream
Bandwidth
Downstream
Bandwidth
Choose the connection type as Dynamic IP if your ISP automatically assigns the IP
address.
Optional. Enter a name for the router. It is null by default.
Specify the upstream bandwidth of the WAN port. The value configured here is the
upper limit of the "Maximum Upstream Bandwidth" on Transmission > Bandwidth
Control > Bandwidth Control page, to make "Bandwidth Control" take effect, please
ensure this parameter is set correctly.
Specify the downstream bandwidth of the WAN port. The value configured here is the
lower limit of the "Maximum Downstream Bandwidth" on Transmission > Bandwidth
Control > Bandwidth Control page, to make "Bandwidth Control" take effect, please
ensure this parameter is set correctly.
WAN Configuration
Configuration Guide 10