Configuring The Advanced Parameters - TP-Link TL-R600VPN Configuration Manual

Configuring VPN
When the LAN-to-LAN mode is selected, the following section will appear.
Remote
Gateway
WAN
Local Subnet
Remote Subnet
Pre-shared Key
Status
When the Client-to-LAN mode is selected, the following section will appear.
Remote Host
WAN
Local Subnet
Pre-shared Key
Status
3) Click OK.

2.1.2 Configuring the Advanced Parameters

Advanced settings include IKEv1 phase-1 settings and IKEv1 phase-2 settings. IKEv1
phase-1 is used to authenticate both sides of the communication and establish the IKE
Enter an IP address or a domain name (1 to 255 characters) as the remote
gateway. 0.0.0.0 represents any IP address. Only when the negotiation mode is
set to Responder Mode can you enter 0.0.0.0.
Specify the WAN port on which the IPSec tunnel is established.
Specify the local network. (It's always the IP address range of LAN on the local
side of the VPN tunnel.) It's formed from the IP address and subnet mask.
Specify the remote network. (It's always the IP address range of LAN on the
remote peer of the VPN tunnel.) It's formed from the IP address and subnet mask.
Specify the unique pre-shared key for both peers' authentication.
Choose to enable the IPSec policy.
Enter the IP address of the remote host. 0.0.0.0 represents any IP address.
Specify the WAN port on which the IPSec tunnel is established.
Specify the local network. (This is the IP address range of the LAN on the local
side of the VPN tunnel.) It's formed from the IP address and subnet mask.
Specify the unique pre-shared key for both peers' authentication.
Choose to enable the IPSec policy.
IPSec VPN Configuration
Configuration Guide 128