TP-Link TL-R600VPN Configuration Manual page 153

Configuring VPN
 Configuring the Router A
1) Choose the menu VPN > IPSec > IPSec Policy to load the following page. Click Add.
Figure 5-2 IPSec Policy List
2) The following page will appear. Specify the IPSec Policy Name as tplink and configure
the Mode as LAN-to-LAN as the network is connected to the other network, then
configure other relevant parameters. Keep Enable selected as the Status of this entry.
Click OK.
Figure 5-3 Configuring the IPSec Policy
3) Choose the menu VPN > IPSec > IPSec Policy and click Advanced Settings to load the
following page. Advanced settings include IKEv1 phase-1 settings and IKEv1 phase-2
settings. You can keep the default advanced settings.
In the Phase-1 Settings section, configure the IKE phase-1 parameters and click OK.
Configuration Examples
Configuration Guide 145