Mantel And Wall Projections - Heatilator CRAVE4836-C Installation Manual

D. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances to combustibles as specified. Framing closer than the
minimums listed must be constructed entirely of noncom-
bustible materials (i.e., steel studs, concrete board, etc.)
If the Passive Heat kit will be installed, see Figure 10.18
for details regarding clearances to combustibles in addi-
tion to the requirements for Combustible and Non-Com-
bustible Mantel diagrams and the Mantel Leg/Wall Pro-
jection diagrams (Figure 10.11-Figure 10.17).
Note: For non-combustible fireplace finish material (marble,
stone, etc) specifications refer to Section 10.A.
TOP OF APPLIANCE OPENING
Figure 10.11 Location of Appliance Opening
Note: Minimum distance from top edge opening to ceiling
can be found in the Framing and Clearances section 3.B.
Combustible Mantels
MAX.
3
1
20
18
MEASUREMENT FROM
TOP EDGE OPENING
Measurement from top edge opening
to bottom of appliance = 24-1/2 IN.
Note: All measurements in inches.
Figure 10.12 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles - CRAVE4836-C,
CRAVE4836ST-C, CRAVE6048-C and CRAVE6048ST-C
Heatilator • CRAVE4836-C/ST-C, CRAVE6048-C/ST-C, CRAVE7260-C/ST-C, CRAVE8472-C/ST-C Installation Manual • 2601-980 Rev. N • 11/21
12
9
6
29
26
23
Note: All measurements in inches.
MAX.
Measurement from top edge opening
to bottom of appliance = 24-1/2 IN.
Figure 10.13 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles - CRAVE7260-C,
CRAVE7260ST-C, CRAVE8472-C and CRAVE8472ST-C
Note: All measurements in inches.
MAX.
4
3
2
1
6
MEASUREMENTS FROM TOP EDGE
OF THE APPLIANCE OPENING
Measurement from top edge of opening
to bottom of appliance = 24-1/2 IN.
Figure 10.14 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles - Passive Heat Kit
Installed (All Sizes)
9
6
3
30
27
24
MEASUREMENT FROM
TOP EDGE OPENING
16
6
5
18
11
10
9
8
7
73