Input Type (Thermocouple) - Omega i Series User Manual

Input Type (Thermocouple)

ENTER INPUT TYPE MENU:
Press a
Press d
Press d
THERMOCOUPLE SUBMENU:
Press b
Press d
Press d
Press b
Press d
Use the Input Type (Thermocouple) (RTD) or (Process) and verify your
Electrical Installation (see section 2.3).
Thermocouple Types:
Display:
1) Press a, if necessary, until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Display flashes T.ç , RTD or PROC (Thermocouple, RTD or
Process). If the displayed input type is T.ç , press a to skip to
step 6 ( T.ç stops flashing).
4) Scroll through the available selection to T.ç (flashing).
5) Display shows STRD stored message momentarily and then
T.ç (not flashing).
6) Display flashes previous thermocouple type selection. i.e. J
(see below for types).
7) Scroll through the available thermocouple types to the
selection of your choice.
8) Display shows STRD stored message momentarily and then
advances to the RDG Reading Configuration Menu.
J, K, T, E, N, DIN J, R, S, B, C
J K T E N DNJ R S B C
18