Table of Contents
Advertisement
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to
the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft. Tighten both bolts to
secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by Hand
Important: Always push the machine by hand.
Never tow the machine because damage may
occur.
To Push the Machine
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to neutral
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position. Make sure the parking brake is
disengaged.
3. Locate the bypass levers at the rear of the machine,
on the left and right side of the frame.
4. Move the bypass levers rearward and then down
to lock them in place as shown in Figure 32 to
disengage the wheel motors. Repeat this on each
side of the machine.
The machine is now able to be pushed by hand.
1
3
To Operate the Machine
Move the bypass to the position for operating the
machine (Figure 32) to engage the wheel motors.
Using the Side Discharge
The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
28
2
4
g017980
Figure 32
Advertisement
Table of Contents
