Table of Contents
Advertisement
then tighten the four leveling adjust locking nuts
(Figure 65).
1
2 3
4
G010342
1. Deck lift arm
2. Deck hanger
3. Leveling adjust locking nut 6. Rear deck hanger bracket
5. Recheck that blocks fit just snugly under the deck
skirt. Make sure all attachment bolts are tight
6. Verify the deck is level by checking the side-to-side
level and front-to-rear blade slope; repeat deck
leveling procedure if necessary.
Inspecting the Belts
Service Interval: Every 50 hours
Check the belts for squealing when the belt is rotating,
blades slipping when cutting grass, frayed belt edges,
burn marks and cracks are signs of a worn mower belt.
Replace the mower belt if any of these conditions are
evident.
Replacing the Mower Belt
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks
are signs of a worn mower belt. Replace the mower belt
if any of these conditions are evident.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
6
1
Figure 65
4. Slot in deck hanger
5. Slot in rear deck hanger
bracket
3. Lower the mower to the 3 inch (76 mm) height-of-cut
position.
4. Remove the belt covers (Figure 66).
3
5
1. Loosen the screws
2. Pivot the belt cover up
5. Using a spring removal tool, (Toro part no. 92-5771),
remove the idler spring from the deck post to remove
tension on the idler pulley (Figure 67).
1
1. Spring removal tool (Toro
part no. 92-5771)
2. Idler spring
3. Deck post
6. Lower the mower to the lowest height-of-cut. Place
the height-of-cut pin in the lock position for lowest
height-of-cut.
47
1
3
G015789
Figure 66
3. Remove belt cover
2
4
G009806
Figure 67
4. Idler arm
5. Mower belt
2
3
5
Advertisement
Table of Contents
