Figure 19
1. Height of cut lever
2. Clevis Pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut it is
recommended to adjust the height of the anti-scalp rollers.
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move levers to neutral locked
position and apply parking brake. Remove the key.
2. After adjusting height-of-cut remove flange nut and
spring disk while holding stud with wrench (Fig. 20).
Note: Do not remove the wheel nut and washer (Fig. 20).
3. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 20).
4. Reinstall the flange nut and spring disk. Torque to
40–45 ft–lbs. (54.2–61.0 N m) (Fig. 20).
5. Repeat adjustment on other gage wheels.
1
2
3
M–4164
3. Hairpin Cotter
22
4
3
2
Figure 20
1. Gage Wheel
2. Stud
3. Spring Disk
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock seat
(Fig. 21).
2. Slide the seat to the desired position and release lever
to lock in position.
1
Figure 21
1. Adjustment lever
Pushing the Machine by Hand
Important
Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
1
5
m–4161
4. Flange Nut
5. Wheel nut and washer.
Do Not Remove.
m–3655