Planar QE Series User Manual page 26

RS232 Codes
Command
Setting
Code
Power POWER.SAVE.
Saving Delay DELAY
Power POWER.SAVE.
Saving Mode MODE
Reboot SYSTEM.REBOOT
Revert REVERT.IMAGE.
Image SETTINGS
Settings
Save and CLONE.SETTINGS
Restore
Settings
Save SAVE.DIAGNOSTICS
Diagnostics
Schedule SCHEDULE
Schedule SCHEDULE.ACTION
Action
26
Modifiers
1406 =?+-
1405 =?+-
2402 !
215 ! Zone
0 = ZONE.1
1 = ZONE.2
2 = ZONE.3
3 = ZONE.4
255 =
CURRENT
[None =
CURRENT]
2315 ! Mod 1:
Operation
0 = COPY
1 = PASTE
Mod 2:
Location
0 = USB
2314 ! Location
0 = USB
2100 =? Mod 1: Slot
1-20
Mod 2:
Parameter
0 = FREQ
1 = MINUTE
2 = HOUR
3 = DAY
4 = ACTION
5 = DATA
6 = ENABLE
[None = ALL]
2102 =? Slot
1-20
Planar QE Series RS232 User Manual
Operands
60 = 1.MINUTE Yes POWER.SAVE.DELAY=5.MINUTES
300 = POWER.SAVE.DELAY:5.MINUTES
5.MINUTES
900 =
15.MINUTES
1800 =
30.MINUTES
3600 =
60.MINUTES
0 = DISABLED Yes POWER.SAVE.MODE=LOW.POWER
1 = LOW.POWER POWER.SAVE.MODE:LOW.POWER
2 = WAKE.ON.
SIGNAL
No SYSTEM.REBOOT
SYSTEM.REBOOT@ACK
No [For Zone 1]
REVERT.IMAGE.SETTINGS(ZONE.1)
REVERT.IMAGE.SETTINGS(ZONE.1)@ACK
[For the current zone]
REVERT.IMAGE.SETTINGS
REVERT.IMAGE.SETTINGS@ACK
No CLONE.SETTINGS(COPY, USB)
CLONE.SETTINGS(COPY, USB)@ACK
No SAVE.DIAGNOSTICS(USB)
SAVE.DIAGNOSTICS(USB)@ACK
Unsigned int Yes [Change the action for event 3 to Turn On]
SCHEDULE(3, ACTION)=0
SCHEDULE(3, ACTION):0
0 = TURN.ON Yes [Change the action for event 3 to Turn On]
1 = TURN.OFF SCHEDULE.ACTION(3)=TURN.ON
3 = PANEL. SCHEDULE.ACTION(3):TURN.ON
BRIGHTNESS
Example
See Main -> Advanced
Settings -> Power -> Power
Saving Delay.
Numeric value is in seconds
and can be used to program
any delay value.
See Main -> Advanced
Settings -> Power -> Power
Saving Mode
Forces the system to restart
See Main -> Image Adjust ->
Revert to Defaults
See Main -> Advanced
Settings -> System Settings ->
Save All Settings to USB
See Main -> Advanced
Settings -> System Settings ->
Restore All Settings from USB
See Main -> Advanced
Settings -> System Settings ->
Save Diagnostics to USB
See Main -> Advanced
Settings -> Schedule -> Set
Event 1-20
Reference the Schedule
Action, Schedule Day and
Schedule Frequency settings
for operand values.
See Main -> Advanced
Settings -> Schedule -> Set
Event 1-20 -> Action
Notes