Kyocera TASKalfa 4002i Operation Manual page 102

Installing and Setting up the Machine > Network Setup
4
5
6
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
2
3
4
5
IMPORTANT
You can connect up to three handheld devices at the same time using Wi-Fi Direct setting. When the devices
that support Wi-Fi Direct are connected, if you want to connect other device, disconnect the already-
connected devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or handheld computer
• Disconnecting all devices from the network on the operation panel
Select [Home] > [Wi-Fi Direct] > [Connected Device List] > [Disconnect All]
• Configuring auto disconnecting time from the System menu
Wi-Fi Direct Settings (page 8-50)
• Configuring auto disconnecting time from the Command Center RX
Command Center RX User Guide
[Home] key > [Wi-Fi Direct]
Note the network name (SSID), IP address, and password.
Configure the handheld device.
1
[Settings] > [Wi-Fi]
2
Select the network name (SSID) appeared in step 5 from the list.
3
Enter the password that was provided in step 5 > [Connect]
The network between this machine and the handheld device is configured.
Display the screen.
[System Menu/Counter] key > [System/Network] > "Network" [Next] > "Wi-Fi Direct
Settings" [Next] > "Wi-Fi Direct" [Change]
Configure the settings.
[On] > [OK]
Restart the network.
[System Menu/Counter] key > [System/Network] > "Network" [Next] > "Restart Network"
[Start] > [Yes]
[Home] key > [Wi-Fi Direct]
Press the push button on the computer or handheld device and
select [Push Button] on the screen of operation panel
simultaneously.
The network between this machine and the computer or handheld device is configured.
2-37