Canon EOS Rebel T6i Instruction Manual page 63

Do not drop the camera on Connect Station or touch the camera to it with

too much force. Doing so may damage Connect Station's internal hard
disk.
Since the camera may not be recognized readily, hold it carefully close to

Connect Station while changing the camera's position or angle.
Just holding the camera close to the Connect Station may not establish a

connection. In such a case, gently touch Connect Station with the
camera.
A connection cannot be established via the NFC function while shooting

with the camera, when the power switch is set to <k>, when there is no
card, or when the LCD monitor is closed with the screen facing inward.
When holding the camera close to the Connect Station, do not leave

anything between the camera and Connect Station. In addition, when a
case is attached to the camera, communication may not be possible via
NFC function.
When Battery Grip BG-E18 (sold separately) is attached, a connection

cannot be established via the NFC function.
If the camera and Connect Station are moved too far away from each

other while importing images, import may take time or the connection
may be terminated.
If the camera's battery runs out during import, the import will stop.

Charge the battery, then try importing again.
A connection can be established even when the camera's power is in the

auto power off state. However, if a connection cannot be established,
cancel auto power off, then establish a connection.
When all images are already imported, import does not start. In such a

case, select [OK] to terminate the connection.
When there are a large number of images on the memory card, it may

take time to check and save the images.
Saving Images
63