Table of Contents
Advertisement
Problem
[] Cloudy or irregular
cubes.
5. Other
Problem
[1] Icemaker will not stop
when bin is filled with
ice.
[] Abnormal noise.
[3] Ice in storage bin
often melts.
Possible Cause
a) Evaporator
b) Water System
c) Spray Guide
Possible Cause
a) Bin Control Thermostat 1. Set too cold.
a) Pump Motor
b) Fan Motor (except
water-cooled models)
c) Compressor
d) Refrigerant Lines
a) Drain Line(s)
b) Icemaker and Bin
c) Ice Cube Guide
1. Frozen up.
. Scaled up.
3. Damaged.
1. Water supply line too
small; requires 1/"
OD line dedicated per
machine.
. Water filter clogged or
flow rate too small.
3. High hardness or
contains impurities.
1. Dirty.
. Defective.
1. Bearings worn out.
1. Bearings worn out.
. Fan blade deformed.
3. Fan blade does not
move freely.
1. Bearings worn out or
cylinder valve broken.
. Mounting pad out of
position.
1. Rub or touch other
lines or surfaces.
1. Plugged.
1. Drains not run
separately.
1. Out of position.
Circulated water falls
into bin.
36
Remedy
1. See chart .
. Clean
3. Replace.
1. Increase water line size.
. Replace filter or install a
higher flow rate filter.
3. Install a water softener or
filter.
1. Clean.
Remedy
1. See "II.F. Bin Control."
. Replace.
1. Replace.
1. Replace.
. Replace.
3. Replace.
1. Replace.
. Reinstall.
1. Reposition.
1. Clean.
1. Separate the drain lines.
1. Place in position.
Advertisement
Table of Contents
