Table of Contents
Advertisement
2.3 Connecting to Fibre HBA
The subsystem supports fibre interface which provides fast 400MB data trans-
fer rate using fibre. This section describes the location of the host channels
and instructions on connecting external fibre devices.
1.
Configure the Loop ID of subsystem or use dynamic LIP.
2.
The package comes with two fibre optical cables. For every pair of host
channel fibre connector at the rear of the subsystem, attach one end of
the fibre optical cable to one of the fibre connectors and the other end
to the host adapter's external fibre connector or to the fibre Hub/Switch.
(The host adapter is installed in your Host subsystem.)
3.
Connect the other host system using the other fibre optical cable if you
want to configure subsystem into multi-host attachment.
Host B
Note:
!
For safety reasons, make sure the Disk Array and Host Computer
are turned off when you plug-in the Fibre cable.
Host A
Getting Started
2-9
Advertisement
Table of Contents
