Table of Contents
Advertisement
1.4.2 Volume Set
A Volume Set is seen by the host system as a single logical device. It is orga-
nized in a RAID level with one or more physical disks. RAID level refers to the
level of data performance and protection of a Volume Set. A Volume Set ca-
pacity can consume all or a portion of the disk capacity available in a RAID
Set. Multiple Volume Sets can exist on a group of disks in a RAID Set. Addi-
tional Volume Sets created in a specified RAID Set will reside on all the physi-
cal disks in the RAID Set. Thus each Volume Set on the RAID Set will have its
data spread evenly across all the disks in the RAID Set. Volume Sets of differ-
ent RAID levels may coexist on the same RAID Set.
In the illustration below, Volume 1 can be assigned a RAID 5 level of opera-
tion while Volume 0 might be assigned a RAID 0+1 level of operation.
1.4.3 Easy of Use features
1.4.3.1 Instant Availability/Background Initialization
RAID 0 and RAID 1 volume set can be used immediately after the creation. But
the RAID 3, 5, 6, 30, 50 and 60 volume sets must be initialized to generate the
parity. In the Normal Initialization, the initialization proceeds as a background
task, the volume set is fully accessible for system reads and writes. The oper-
ating system can instantly access to the newly created arrays without requiring
a reboot and waiting the initialization complete. Furthermore, the RAID volume
set is also protected against a single disk failure while initialing. In Fast
Initialization, the initialization proceeds must be completed before the volume
set ready for system accesses.
1.4.3.2 Array Roaming
The RAID subsystem stores configuration information both in NVRAM and on
the disk drives It can protect the configuration settings in the case of a disk
drive or controller failure. Array roaming allows the administrators the ability to
move a completely raid set to another system without losing RAID configura-
Introduction
1-14
Advertisement
Table of Contents
