Table of Contents
Advertisement
The modulating furnace airflow during heating is still controlled by the ignition control not the
Touch Screen Communicating Control.
Edit/Add Devices
11:07AM Thu 21 Jul
Select a device to edit/add information:
System ID = HP14
Other:
Add
Device
Furnace
Other:
Humidifier
Maint Reminder
11:07AM Thu 21 Jul
1st Maintenance Reminder
recurring every:
Enabled
2nd Maintenance Reminder
recurring every:
Disabled
Warning Alert:
2 Weeks in Adv
Dealer Info
11:07AM Thu 21 Jul
Logo
Johnson Controls Unitary Products
NOTICE
Heat Pump
Back
Next
08
/
May
Back
Next
Dealer Name
Dealer Phone Number(s)
Dealer Address 1
Dealer Address 2
Dealer Email
Dealer Website
Edit
Back
Next
The Edit/Add Devices screen is shown for every
system install. For the system to properly control
accessories, they must be "ADDED" using this
screen. The information displayed will depend on
the system being installed. Accessories such as
humidifiers, EAC, and UV lights are not commu-
nicating, and model and serial numbers can be
manually entered. For more information on the
function of this screen refer to the Service Mode
section of this document.
Maintenance Reminder screen is shown for
every
system
install.
Reminder can be entered by enabling the
reminder and selecting the desired day and
month. These are set up as you choose based
on your business plan (i.e., do you want the hom-
eowner to call for maintenance or not?). Two
maintenance reminder events may be estab-
lished (fall and spring).
The Dealer Information screen is shown for
every system install. This screen is for dealer
information entry. Text can be entered with the
keyboard or imported. For more information on
the function of this screen refer to the Service
Mode section of this document. This is the final
setup screen. Once completed you can exit ser-
vice mode for normal operation.
NOTE: For more information see "Navigating
Service Mode: Master control" under SECTION
VI of this document.
1078329-UIM-A-0114
Annual
Maintenance
19
Advertisement
Table of Contents
