Basic Ip Commands - Extreme Networks Summit Summit24 Installation And User Manual

Table 48: Basic IP Commands
Command
clear iparp {<ipaddress> <mask> | vlan <vlan>}
clear ipfdb {<ipaddress> <netmask> | vlan <name>} Removes the dynamic entries in the IP
config bootprelay add <ipaddress>
config bootprelay delete [<ipaddress> | all]
config iparp add <ipaddress> <mac_address>
config iparp add proxy <ipaddress> {<mask>}
{<mac_address>} {always}
config iparp delete <ipaddress>
config iparp delete proxy [<ipaddress> {<mask>} |
all]
config iparp timeout <minutes>
disable bootp vlan [<name> | all]
disable bootprelay
disable ipforwarding {vlan <name>}
disable ipforwarding broadcast {vlan <name>}
disable loopback-mode vlan [<name> | all]
enable bootp vlan [<name> | all]
enable bootprelay
Summit24e3 Switch Installation and User Guide
Description
Removes dynamic entries in the IP ARP
table. Permanent IP ARP entries are not
affected.
forwarding database. If no options are
specified, all dynamic IP FDB entries are
removed.
Adds the IP destination address to forward
BOOTP packets.
Removes one or all IP destination
addresses for forwarding BOOTP packets.
Adds a permanent entry to the ARP table.
Specify the IP address and MAC address
of the entry.
Configures proxy ARP entries. When mask
is not specified, an address with the mask
255.255.255.255 is assumed. When
mac_address is not specified, the MAC
address of the switch is used in the ARP
Response. When always is specified, the
switch answers ARP Requests without
filtering requests that belong to the same
subnet of the receiving router interface.
Deletes an entry from the ARP table.
Specify the IP address of the entry.
Deletes one or all proxy ARP entries.
Configures the IP ARP timeout period. The
default setting is 20 minutes. A setting of 0
disables ARP aging. The maximum aging
time is 32,767 minutes.
Disables the generation and processing of
BOOTP packets.
Disables the forwarding of BOOTP
requests.
Disables routing for one or all VLANs.
Disables routing of broadcasts to other
networks.
Disables loopback-mode on an interface.
Enables the generation and processing of
BOOTP packets on a VLAN to obtain an
IP address for the VLAN from a BOOTP
server. The default setting is enabled for
all VLANs.
Enables the forwarding of BOOTP and
Dynamic Host Configuration Protocol
(DHCP) requests.
IP Commands
173