Configure The Switch's Ip Address For The Management Vlan; Change The Switch Os Via The Bootloader Menu - Extreme Networks 7720 Installation Manual

Hide thumbs Also See for 7720:
Table of Contents

Advertisement

Configure the Switch's IP Address for the Management
VLAN

Configure the Switch's IP Address for the Management VLAN

You can configure the switch's IP address for the management virtual LAN (VLAN).
Note
The management port is part of the mgmt VLAN. This VLAN membership
cannot be changed.
Log in to the management console, connect to the switch, and follow these steps.
1. Assign a name, IP address, and default subnetwork mask for the VLAN as shown
in the following example. configure vlan vlan_name ipaddress nn.nn.nn.nn
255.255.255.0
Your changes take effect immediately.
2. Enter save to save your configuration changes so that they will be in effect after the
next system reboot.
The configuration is saved to the configuration database of the switch.

Change the Switch OS via the Bootloader Menu

Onboard your switch with ExtremeCloud™. Log in or create your XIQ administrator
account in order to select your switch operating system with XIQ at
extremecloudiq.com.
Switch Engine is the default operating system for the Universal Hardware switch. You
can change the switch OS from the Bootloader menu on initial activation only by
completing the following steps:
1. Using a terminal emulator such as PuTTY or TeraTerm, connect to the switch using
the serial port connection.
Be sure that your serial connection is set properly:
Baud rate: Baud rate: 115200
Data bits: 8
Stop bit: 1
2. Once the switch is powered on, after seeing the "Boot Menu" screen, press the
[spacebar] key within 30 seconds.
3. Use the down-arrow key to select Change the switch OS to Fabric Engine, then
select Enter.
The switch installs Fabric Engine, then resets. Once the NOS is selected, the "Boot
Menu" will only wait for 3 seconds before continuing.
To change the switch OS if you take no action during the initial boot, see
Switch OS via the Startup Menu
64
Extreme 7720 Hardware Installation Guide
Note
For more information about saving configuration changes, see the
Switch Engine 32.4 User Guide
on page 65.
Activate and Verify the Switch
.
https://
Change the

Advertisement

Table of Contents
loading

This manual is also suitable for:

7720-32c7720-32c-ac-f7720-32c-ac-r

Table of Contents