Configuring Rip - Extreme Networks Summit 200-24 Installation And User Manual

Configuring RIP

Table 61 describes the commands used to configure RIP.
Table 61: RIP Configuration Commands
Command
config rip add vlan [<name> | all]
config rip delete vlan [<name> | all]
config rip garbagetime {<seconds>}
config rip routetimeout {<seconds>}
config rip rxmode [none | v1only | v2only | any]
{vlan <name>}
config rip txmode [none | v1only | v1comp |
v2only] {vlan <name>}
config rip updatetime {<seconds>}
config rip vlan [<name> | all] cost <number>
enable rip
Summit 200 Series Switch Installation and User Guide
Description
Configures RIP on an IP interface. When an IP
interface is created, per-interface RIP
configuration is disabled by default.
Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
Configures the RIP garbage time. The timer
granularity is 10 seconds. The default setting is
120 seconds.
Configures the route timeout. The default
setting is 180 seconds.
Changes the RIP receive mode for one or all
VLANs. Specify:
• none—Drop all received RIP packets.
• v1only—Accept only RIP v1 format
packets.
• v2only—Accept only RIP v2 format
packets.
• any—Accept both RIP v1 and v2 packets.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is any.
Changes the RIP transmission mode for one or
all VLANs. Specify:
• none—Do not transmit any packets on this
interface.
• v1only—Transmit RIP v1 format packets
to the broadcast address.
• v1comp—Transmit RIP v2 format packets
to the broadcast address.
• v2only—Transmit RIP v2 format packets
to the RIP multicast address.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is v2only.
Changes the periodic RIP update timer. The
default setting is 30 seconds.
Configures the cost (metric) of the interface.
The default setting is 1.
Enables RIP. The default setting is disabled.
Configuring RIP
203