Change Settings
6.4.1 Transfer the Foil Only onto the Upper Part of the Sheet (Top)
Specify the length of foil you want to transfer onto the sheet, leaving the remaining areas blank.
1 Feed direction
2 Margin of 5 mm without any toner-based print
3 Transfer area
(The foil will be transfered only onto this area)
4 Blank area
(This area must not contain any toner-based print)
a
Press
(Foil Save).
The Foil Save Mode settings screen appears on the LCD.
Note
You can also press
b
Press ▼ or ▲ to select [Top] and then press
c
Press ▼ or ▲ to select the length of foil you want to transfer from the top edge of the sheet (between
50 mm and 170 mm), and then press
d
To exit Foil Save Mode press
e
Press
(Start).
1
1 2 3
4 5
(Menu), press ▼ or ▲ to select [Foil Save Mode], and then press
(OK).
(Stop/Exit), and then load the media.
2
3
6
4
(OK).
6
(OK).
32