Alarm - Panasonic KX-TGMA44AZ Operating Instructions Manual

To turn this feature on, select "Caller ID auto". To turn this feature off, select
"Manual". (Caller ID subscribers only)
To use this feature, set the date and time first (page 21).
*4 The preset ringers in this product ("Ringer 6" - "Ringer 15") are used with permission
of © 2004 - 2013 Copyrights Vision Inc.
*5 If you select one of the ringers ("Ringer 1" to "Ringer 5"), select the desired frequency
("Frequency 1" to "Frequency 6").
*6 This setting is available when you have the key finder (KX-TGA20). Read the installation
manual for more information on the key finder.
*7 For models with supplied key finders, the display shows "1: Finder1".
*8 If you register 2 or more key finders.
*9 If you subscribe to a Caller ID service and want to view the caller's information after lifting up
the handset to answer a call, turn off this feature.
*10 The recall time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
You can access your phone service provider "call waiting" service by having the recall time
set at "100 ms", and then follow your phone service provider "call waiting" instructions to
operate this service. (for Australia)
*11 The default setting will be as follows if you select the following regional codes when
changing the unit's region setting (page 47):
"New Zealand" = "600 ms"
*12 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to "A" if telephone line condition is not good.

Alarm

An alarm sounds at the set time for 1 minute
and repeats 5 times at 5 minute intervals
(snooze function). You can also configure the
alarm to display a text memo. You can set 3
separate alarms for each handset. Each alarm
can be set to sound once, daily, or weekly.
When an alarm sounds, the message indicator
flashes rapidly if the handset message
indicator's "Alarm" setting is enabled
(page 27).
Important:
R Make sure the unit's date and time setting
is correct (page 21).
1
MMENUN#720
2
MbN: Select the desired alarm. a
MSELECTN
3
MbN: Select the desired alarm option. a
MSELECTN
"Off"
Turns alarm off. Go to step 10.
"Once"
An alarm sounds once at the set time.
"Daily"
An alarm sounds daily at the set time.
Go to step 5.
"Weekly"
Alarm sounds weekly at the set time(s).
4
Proceed with the operation according to
your selection in step 3.
n Once:
Enter the desired month and date. a
MOKN
n Weekly:
MbN: Select the desired day of the week
and press MSELECTN. a MOKN
5
Set the desired time.
Programming
45