Table of Contents
Advertisement
SET UP INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
-
Wrecking bar
-
Claw hammer
-
Sockets: 1/2", 15/16
-
Wrenches: 18mm, 1/2", 9/16", 3/4", 15/16"
-
Tire pressure gauge
NOTE: All references below to the "right" or "left" are with respect to an operator at the controls.
1. UNCRATE UNIT
a) Discard packing materials. Loosen the caster wheel axle bolts and bumper bolts to remove the shipping
brackets.
Discard shipping brackets.
b) Re-install and tighten bumper bolts.
c) Tighten caster wheel axle bolts against caster axle spanner bushings to 80 ft/lbs.
2. TIRE PRESSURE
a) Set tire pressures to 14 lbs/in
3. TRACTION LEVERS
a) Tighten bolt A.
b) Sit on the machine. Levers C may be moved to
upper set of holes in bar B for a better operator
fit.
12
). Tires are overinflated for shipping.
2
(1.0 kg/cm
2
WOODS
Advertisement
Table of Contents
