Dealer Set-Up Instructions - Woods MOW'N MACHINE FZ22K Operator's Manual

DEALER SET-UP INSTRUCTIONS

Assembly of this Mow'n Machine is the responsibility of
the Woods dealer. It should be delivered to the owner
completely assembled, lubricated, and adjusted for
normal cutting conditions.
Set up the Mow'n Machine as received from the factory
with these instructions. Complete the Dealer Check
Lists on page 27 when assembly is completed.
Power Unit Preparation
1. Remove crating from around power unit. Remove
power unit from pallet and place on blocks.
2. Remove Operator's Manual from power unit frame
and save for original retail purchaser.
NOTE: Dealer must complete and return product
registration card at time of sale.
Lubrication
NOTICE
■
Running engine without oil will cause engine
failure.
1. Check engine oil level (30W).
2. Check that oil levels (20W-50) in hydro expansion
tank are at correct level.
NOTE: See Owner Service section for engine,
transmission, and lubrication information.
Fuel
Fill fuel tank with the correct fuel. Refer to engine man-
ual.
INSTALL DRIVE TIRES
Figure 12. Drive Tire Installed
MAN0999 (12/4/2012)
ASSEMBLY
1. Install drive tires using five lug nuts (1) from bag of
loose parts shipped with machine.
2. Torque lug bolts to 85 lbs-ft.
TAIL WHEEL INSTALLATION
Dual Tail Wheel
1. Attach pivot mount adapter to rear of power unit
frame using 4 flange screws.
2. Slide tail wheel arm over pivot.
3. Attach arm with large flat washer (2), lock washer
(3) and screw (4).
4. Torque hardware to 38 FT-LB.
5. Inflate tires to 18 psi.
Single Tail Wheel
1. Attach mount adapter to rear of power unit frame
using 4 flange screws (1).
2. Torque hardware to 38 FT-LB.
3. Inflate tire to 18 psi.
1
DP105
Drive Tire Pressure:
Turf Tires 12 psi
Chevron Tires 10 - 12 psi
2
3
4
Figure 13. Dual Tail Wheel Installed
Assembly 25
1
DP105