Aligning And Sharpening Masonry Drill Bits - Drill Master X2 User Manual

Aligning and Sharpening Masonry Drill Bits

To sharpen a masonry bit, you do not turn the Chuck, instead
you use a plunging motion. Insert the Chuck until it touches the
wheel, remove, and repeat on the other side.
Alignment Finger
Plunge until sharp
Align the White Triangle on the Chuck with the Cam Pin on the
machine. Plunge the Chuck into the Sharpening Port until it
contacts the Sharpening Wheel. Remove the Chuck and rotate
one half-turn to the opposite White Triangle. Plunge the Chuck
into the Sharpening Port again to sharpen the other side of the
carbide insert. Start with four plunges. Inspect the bit. Then
sharpen more if needed.
18
Chuck the masonry bit.
Insert your masonry bit in the Chuck
in the same manner as other bits, but
in this case, make sure the carbide
Carbide Insert
Tighten
Tighten the Chuck while checking that
the insert is touching the end of the
Alignment Fingers. Tighten until the bit
no longer moves in the chuck.
insert is touching the
end of the Alignment
Fingers as shown.
www.drilldoctor.com