Table of Contents
Advertisement
1.
On cutting unit numbers 2, 4, and 6, remove the
2 cap screws securing the counterweight to the
left end of the cutting unit.
Note:
Remove the counterweight
Figure 10
1. Counterweight
2.
On the right end of the cutting unit, remove the
plastic plug from the bearing housing
11).
3.
Remove the 2 cap screws from the right side
plate
(Figure
11).
Figure 11
1. Plastic plug
4.
Install the counterweight to the right end of
the cutting unit with the 2 screws previously
removed.
5.
Loosely install the 2 reel motor mounting cap
screws to the left side plate of the cutting unit
(Figure
11).
(Figure
10).
g003320
(Figure
g003321
2. Cap screw (2)
5
Installing the Cutting Units
Parts needed for this procedure:
5/7
Large O-ring
2
Screw
Procedure
1.
Insert a thrust washer onto the horizontal shaft
of the pivot knuckle as shown in
1. Carrier frame
2. Pivot knuckle
3. Lift-arm steering plate
2.
Insert the horizontal shaft of the pivot knuckle
into the mounting tube of the carrier frame
(Figure
12).
3.
Secure pivot knuckle to carrier frame with a
thrust washer, a flat washer, and a flange-head
cap screw
(Figure
4.
Insert a thrust washer onto the vertical shaft of
the pivot knuckle
5.
If removed, insert the vertical shaft of the pivot
knuckle into the lift-arm pivot hub
6.
Guide the pivot knuckle in place between the 2
rubber centering bumpers in the underside of
the lift-arm steering plate.
7.
Insert the lynch pin into the cross hole on the
pivot-knuckle shaft
8.
Secure the lift arm chain to the cutting unit chain
bracket
(Figure
follows:
8
Figure
Figure 12
4. Lynch pin
5. Steering locking pin
12).
(Figure
12).
(Figure
(Figure
12).
13) with the snapper pin as
12.
g006532
12).
Advertisement
Table of Contents
