Setup; Removing The Tipper Assemblies - Toro 03698 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Removing the Tipper
Assemblies
No Parts Required
Procedure
Remove the tipper assemblies (if so equipped) from
the number 1, number 2, and number 3 lift arms
to avoid interference with the carrier frames of the
cutting units.
1. Remove the locknut and the washer securing
the pivot rod to the number 2 lift arm
3). Remove the pivot rod and spring from the
Description
No parts required
Lift chain
Chain bracket
U-bolt
Nut
Screw
Washer
Nut
No parts required
No parts required
Large O-ring
Screw
(Figure
Qty.
–
5/7
5/7
5/7
10/14
5/7
5/7
5/7
–
–
5/7
2
Qty.
1
Review the material and save it in an appropriate place.
–
lift arm. Repeat the procedure on the number 1
and number 3 lift arms.
1. Pivot rod
Note:
tipper support brackets are not required when
operating the DPA cutting units
5
Use
Remove the tipper assemblies.
Mount the lift brackets and chains.
Adjust the cutting unit
Mount the counterweights.
Install the cutting units.
Use
Figure 3
2. Tipper support bracket
w/roller
The tipper bracket with the roller and the
g006533
(Figure 3).