Servicing The Bedbar - Toro 03698 Operator's Manual

Checking the Top Grind Angle
The angle that you use to grind your bedknives is
very important.
Use the angle indicator (Toro Part No. 131-6828) and
the angle-indicator mount (Toro Part No. 131-6829) to
check the angle that your grinder produces and then
correct for any grinder inaccuracy.
1. Place the angle indicator on the bottom side of
the bedknife as shown in
Figure 34
1. Bedknife (vertical)
2. Press the Alt Zero button on the angle indicator.
3. Place the angle-indicator mount on the edge of
the bedknife so that the edge of the magnet is
mated with the edge of the bedknife
Note:
The digital display should be visible from
the same side during this step as it was in step 1.
Figure 35
1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown
in Figure 35.
Note:
This is the angle that your grinder
produces; it should be within 2 degrees of the
recommended top grind angle.
Figure 34.
g034113
2. Angle indicator
(Figure 35).
g034114
3. Bedknife
4. Angle indicator

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar-adjusting screws
counterclockwise to back the bedknife
away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer
is no longer tensioned against the bedbar
(Figure 36).
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
4. Remove each bedbar bolt, allowing the bedbar
to be pulled downward and removed from the
machine bolt (Figure
washers and 1 stamped steel washer on each
end of the bedbar
21
(Figure 36).
Figure 36
3. Bedbar
4. Washer
(Figure 37).
Figure 37
2. Locknut
37). Account for 2 nylon
(Figure 38).
g006498
g003334