Table of Contents
Advertisement
2.
Disconnect the lift chains from the cutting units,
if attached.
2
Mounting the Lift Brackets
and Chains
Parts needed for this procedure:
5/7
Lift chain
5/7
Chain bracket
5/7
U-bolt
10/14
Nut
5/7
Screw
5/7
Washer
5/7
Nut
Procedure
Mount a chain bracket to each lift arm with a U-bolt
and 2 nuts. Position the brackets as follows:
Note:
Refer to
Figure 4
number being described.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
5. Cutting unit 5
1.
On lift arm numbers 1, 4, and 5, position the
chain brackets and U-bolts 38.1 cm (15 inches)
behind the center line of the pivot knuckle
(Figure
5).
2.
On lift arm numbers 1 and 5 the brackets should
be rotated to the right 10 degrees from vertical
(Figure
5).
3.
On lift arm number 4 the bracket should be
rotated to the left 10 degrees from vertical
(Figure
5).
to determine the lift arm
Figure 4
6. Cutting unit 6
7. Cutting unit 7
8. Reel motor
9. Weight
1. Lift arm number 5 =
38.1 cm (15 inches)
2. Lift arm number 4 =
10 degrees
4.
On lift arm numbers 2 and 3, position the
brackets and U-bolts 38.1 cm (15 inches) behind
the center line of the pivot knuckle
Note:
Rotate the brackets 45 degrees to the
outboard side of the machine.
g034112
1. Lift arm number
2 = 38.1 cm
(15 inches)
6
Figure 5
3. Lift arm numbers 1 and 5 =
10 degrees
(Figure
Figure 6
2. Lift arm number 3 =
45 degrees
g020546
6).
g020547
Advertisement
Table of Contents
