Huawei AP Series Quick Start Manual page 18

Installing the AP
(5) Tighten the Socket and Shell using hand until you
can„t see the red color band.
Red color band
Before tightened the socket and shell, the cable
can't be tightened by the nut.
c Verification
Use a multimeter to test the reliability of the cable
components.
d Protection
The device is placed outdoors, warp up the connector using three layers of PVC insulation tapes to prevent
it from being damaged, as shown in the following figure.
NOTE
 Each radio connector must be wrapped by three layers of waterproof tape and three layers of
insulating tape.
 Wrap the tape from bottom to top, from top to bottom, and then from bottom to top. Cut the tape after
wrapping three layers of tape on the connector.
 Wrap each layer of tape tightly and ensure that each layer covers more than 50% of the layer below it.
 Before wrapping the waterproof tape, stretch the tape evenly until the tape turns 1/2 as wide as before.
 After wrapping the tape, bundle cable ties at both ends of the insulating tape to prevent aging of the
tape.
 Connecting the ground cable
Cut the cable of proper length, and select 6-M4 OT terminal for the AP and 6-M6 OT terminal for the
ground bar.
(6) Pre-tighten the nut and socket, and then further
tighten the nut using a wrench with a torque of
more than 1.2N· m.
Nut
Please be careful not to damage the surface coating
of parts when tightening the nut and socket.
 Connector jacks can't be short-circuited.
 Connections between the metal shell and the
connector jacks can't be short-circuited.
 Cable core wires are connected properly to the
corresponding connector jacks.
17
Wrench specifications:22
Connecting the
ground bar