Huawei AP Series Quick Start Manual page 16

Installing the AP
 Connecting the feed line
(1) The outdoor AP's antenna ports already have 5 KA surge protection capability. Generally, no surge
protection devices need to be installed; therefore, the antenna cables are directly connected to the AP's
antenna ports.
(2) If higher surge protection capability is required, the customer can purchase a surge protection device.
When installing the surge protection device, ensure that it is connected to a ground cable.
a
Surge
protection
device
Feed line
NOTE
 When no antenna is installed on the 5G antenna interface, cover the interface with a dustproof
cap and wrap the dustproof cap with insulating tape and waterproof tape.
 Wrap the feed line using one-layer PVC black insulation tape, three-layer waterproof adhesive
tape, and then three-layer PVC black insulation tape.
 Stretch the waterproof adhesive tape evenly and ensure that the upper layer of the tap overlaps
1/2 of the lower layer. Each layer should be attached tightly.
 Wrap the three-layer waterproof adhesive tape from bottom to up, from up to bottom, and from
bottom to up in order.
 Connecting optical fibers
(1) The right figure shows the appearance of the optical fiber：
(2) The optical fiber connection of AP6610DN-AGN is similar to that of WA653SN. Here, WA653SN is
used as an example. Connect the optical fiber to the AP and ensure that the waterproof connector is
fastened.
b
NOTE
Install an optical module as shown in step a before connecting the fiber.
a b
Feed line
b c
d
c
c
Ground cable
Waterproof
adhesive
tape
e
f
d e
15
Waterproof adhesive tape
f