Table of Contents
Advertisement
DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Firmware Update
On the System / Firmware Update page, you can update the firmware of the router and
configure the automatic check for updates of the router's firmware.
Update the firmware only when the router is connected to your PC via a wired
!
connection.
The current version of the router's firmware is displayed in the Current firmware version field.
By default, the automatic check for the router's firmware updates is enabled. If the Access point,
Repeater, or Client mode was selected in the Initial Configuration Wizard and the Static value is
selected from the Mode of local IP address assignment list on the Connections Setup /
LAN page, the Gateway IP address field should also be filled in on order to realize automatic
check.
If a firmware update is available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the left and click the APPLY SETTINGS button.
To enable the automatic check for firmware updates, in the Remote Update section, move the
Check for updates automatically switch to the right and click the APPLY SETTINGS
button. By default, in the Remote server URL field, the D-Link update server address
(fwupdate.dlink.ru) is specified.
You can update the firmware of the router locally (from the hard drive of your PC) or remotely
(from the update server).
Figure 168. The System / Firmware Update page.
Page 214 of 236
Configuring via Web-based Interface
Advertisement
Table of Contents
