Soleus Air WS1-06E-02 Operating Instructions Manual page 9

INSTALLATION
Placing the Unit Inside a Normal Window
1. Set the unit in the window so that is centered. Place the
unit so that front edge of the bottom rail is against the back
edge of the sill.
2. Bring the window down so that the front edge of the top
rail is in front of the window. Be sure the unit is tilting
slightly to the outside.
Window
Frame
Top Rail
Bottom Rail
3. Once the air conditioner is placed, extend the left and
right curtains to the width of the window.
4. Place the curtain lock between the curtain extensions and
the window sill, drive long screws through the lock and into
the sill as shown below:
Foam Seal
Sash Lock
Window Sill
Curtain Locks
5. Secure the left and right flanges with long screws on the
bottom sides of the curtain.
6. Drive long screws through upper frame holes into win-
dow sash.
7. Attach the sash lock to the place between the upper and
lower sashes and secure it with long screws. Each side uses
2 long screws.
8. Cut the foam seal to the window width and insert the sash
seal between the glass and the window to prevent air and
insects from getting into the room.
9. For added insulation, the insert strip can be installed
between the air conditioner and window sill. This is option-
al.
1/4"
1.
2.
3.
Remove the Air Conditioner from the Window
1. Turn the air conditioner off, and disconnect the
power cord.
Curtain
2. Remove the sash seal from between windows,
and unscrew sash lock.
3. Remove the screws installed through the frame
and frame lock.
4. Close (slide) the side panels into frame.
Flange 5. Keeping a firm grip on air conditioner, raise the sash
and carefully "rock" air conditioner backward to
drain any condensation water in base of unit. Be
careful not to spill any remaining water while lifting
unit from window.
6. Store parts with the air conditioner in the box.
Weather Insulation Board Installation
NOTE: The Weather Insulation Board adds an extra layer of
insulation to keep air from passing through the sides of the
window air conditioner.
Using a sharp blade or scissors, slowly cut the Weather
Insulation Board to a size that will fit the inside curtain
rails and completely cover the curtain.
Once properly sized, remove the backing to expose the
adhesive tape.
Place the Weather Insulation Board over the left and right
curtain and firmly press and hold for 5 seconds.
(End of Season)