Table of Contents
Advertisement
- When installing the Width driving block, install the Intensity driving shaft
pinion and the Intensity gear with each gears bitten correctly. You do not
need to adjust the position with the Intensity sensor.
*If you operate the Massage chair with the gears bitten incorrectly, it may cause
the crack of the gears.
10.13.13. Removing the Up/down shaft(Up/down shaft bolt)
*Work with the Massage mechanism block unloaded.
1. Unscrew the Up/down shaft bolt with the 13mm-diameter box driver and a
screwdriver.
Caution when installing
- Tightening the Up/down shaft bolt too tightly may break the bolt. Be sure to
use the torque wrench and tighten the bolt with the tightening torque 35 -
45kgfcm(350 - 450Ncm).
90
Advertisement
Table of Contents
