Table of Contents
Advertisement
3 pcs. each).
6. Using the manual operation of the controller, conduct the rolling operation. Set
the massage heads adjustment switch to level 1, and check the up/down stroke.
10.11. Installing the Connecting cord for power source
Move the Massage mechanism block to the highest position.
*After installing each Connecting cords, be sure to confirm that each Connecting
cords do not touch belts or Rear cover fixing plate or being stuck in the gear by
operating the Up/down button in the controller manual mode. Also confirm that
each Connecting cords are not extremely tense at the highest position.
Caution
After moving the Massage mechanism block to the highest position, install the
Rear cover so as to avoid each Connecting cords being stuck. Wind the cords
around the Wire.
79
Advertisement
Table of Contents
