Panasonic EP3203-U1 Service Manual page 82

1. Disconnect the Connector (CN206)(1) on the Main PCB.
2. Cut off the Insulated tie medium (2) of the lead wires.
3. Unscrew two installation screws (3) of the Up/down gear box B and the Up/down
sensor plate and remove the Up/down sensor.
Caution when installing
When installing the Up/down sensor, be sure to insert the Sensor plate to the
groove of the Up/down gear box B.
10.13.2. Removing the Body pressure sensor
1. Disconnect the Connector (CN206)(4) on the Main PCB.
2. Cut off the Insulated tie medium (5) and the Insulated tie small (6) of the lead
wires.
3. Unscrew a screw (7) of the Intensity gear box B.
4. Remove the Body pressure sensor(8).
Caution when installing
- When removing the Body pressure sensor, do not pull the Lead wires
strongly. Handle the PCB carefully.
- Be careful of the installation directions.
- When installing the Body pressure sensor, make the 0-point adjustment
with loaded on the Massage mechanism block.
82