Table of Contents
Advertisement
1. Before mounting, the Massage mechanism block on the back frame must be
moved down to the lowest position by setting the controller manual operation
massage head adjustment button to Down.
2. Make sure that the Massage mechanism block has been mounted horizontally by
moving the Massage mechanism block to the position shown in the figure.
Unless the Massage mechanism block has been mounted horizontally, an
abnormal sound or problem may occur.
3. Move it up to the highest position (until the massager stops) by setting the
controller manual operation
Massage head adjustment button to up.
4. Peeping into the square hole of the back frame, check the position of the
massager to adjust.
*One thread of the up/down detection gear gives a stroke change of 4mm.
When the massager has been raised excessively : Turn the up/down detection gear
counterclockwise to adjust.
When the massager has been lowered excessively : Turn the up/down detection
gear clockwise to adjust.
While adjusting the distance between the square hole and Guide roller assy. to
10mm, check by using the up/down adjustment button found on the manual
operation panel of the controller.
5. Install the rail piece A and B, and tighten uniformly the set screws (left and right,
78
Advertisement
Table of Contents
