Panasonic EP3203-U1 Service Manual page 83

10.13.3. Removing the Intensity sensor
1. Disconnect the Connector (CN205) (9) on the Main PCB.
2. Cut off the Insulated tie medium (10) of the lead wires.
3. Unscrew a screw (11) of the Massage mechanism block and the Intensity sensor
plate.
Caution when installing
- Make sure that the grooves of the Massage mechanism block frame and the
Intensity sensor meet each others.
- When fixing Lead wires with insulated ties, be careful so that Lead wires do
not hook anything.
10.13.4. Removing the Width sensor
1. Disconnect all the Connectors on the Main PCB.
2. Cut off the four Insulated ties medium (2) (5) (10) (18), one small (12).
3. Unscrew five screws (13) on the Main PCB installation plate and four screws (14)
and three screws (15).
4. Cut off two Insulated tie medium (16) of the Air hoses and unscrew two screws
(17).
5. Take off the Snap pin of the Sensor plate.
Caution when installing
- When fixing Lead wires with insulated ties, make sure that the Lead wires
are not pulled moving the Massage mechanism block for the Intensity
directions.
83