Table of Contents
Advertisement
10.13.6. Removing the Air unit
1. Disconnect Connectors (CN201, CN208) of the Main PCB.
2. Unscrew five screws of the Main PCB installation plate and four screws of the Air
unit.
3. Cut off the Insulated tie medium of the Air hoses.
Caution when installing
- You can remove the Air unit with the five screws loose of the Main PCB
installation plate.
10.13.7. Removing the Width motor
1. Disconnect Connectors (CN102, CN500) of the Main PCB.
2. Cut off one Insulated tie medium, and two small.
3. Remove the Width belt.
4. Unscrew four screws of the Width motor.
10.13.8. Removing the Back vibrator
1. Disconnect Connectors (CN2102, CN211) of the Main PCB.
2. Cut off three Insulated ties medium of the Lead wires.
3. Unscrew two screws of the Back vibrator.
Caution when removing
85
Advertisement
Table of Contents
