Table of Contents
Advertisement
9. (LOG H): Locate the pin for Log H in Figure 4. Place
Log H into the appliance as shown in Figure 13. The
base of the log should rest against the log pin and also
contact the grate tine. The top of Log H will rest on Log
A and be spaced about one inch from Log G.
F
APPROXIMATELY 1 IN.
G
A
C2
LOG CONTACTS GRATE TINE
LOG RESTS AGAINST LOG PIN
Figure 13. Log H Installed
10. (LOG E2): Place Log E2 into the appliance as shown
in Figure 14 with the burned out portion toward the
center of the appliance. The base of the log will be in
the right rear corner, contacting both the rear and right
side refractory. The flat (bottom) side of the log will
rest on Log H, approximately equally spaced between
the top and bottom . See Figure 3 for completed log
set installation.
LOG E2 CONTACTS BACK & SIDE
REFRACTORY IN REAR CORNER
F
G
A
C2
NEARLY EQUAL SPACES
Figure 14. Log E2 Installed
Note: See section 11.E of appliance installation manual
for details on placement of lava rock and embers.
62
Majestic • DBDV36PLATIN, DBDV36PLATIL, DBDV42PLATIN, DBDV42PLATIL Installation Manual • 2454-980 Rev. F • 5/17
H
E2
H
2454-935B
Advertisement
Table of Contents
