Table of Contents
Advertisement
LOG INSTALLATION:
Note: Logs are placed in appliance in alphabetical order.
1. (LOG A):
Place Log A into appliance as shown in
Figure 5. The notch on the bottom of the left end should
rest on the left grate tine. The right end of Log A should
rest against the rear of the right grate tine, and in front of
the "Log A" pin indicated in Figure 4. Slide Log A toward
the front of the appliance.
NOTCH FOR LOG G
NOTCH FOR LOG B
LOG RESTS ON LEFT GRATE TINE
LOG CONTACTS RIGHT GRATE TINE
Figure 5. Log A Installed
2. (LOG B): Locate the pin for Log B on Figure 4. Position
Log B in the appliance with the notches in the log toward
the rear of the appliance. The log should contact the log
pin at the rear. Place the front of Log B in the notch on
Log A. See Figure 6.
B
NOTCH FOR LOG C
A
LOG CONTACTS
LEFT GRATE TINE
Figure 6. Log B Installed
Majestic • DBDV36PLATIN, DBDV36PLATIL, DBDV42PLATIN, DBDV42PLATIL Installation Manual • 2454-980 Rev. F • 5/17
NOTCH FOR LOG F
A
NOTCH FOR LOG D
A
B
3. (LOG C): Locate the pin for Log C in Figure 4. Position
Log C in the appliance with the bark end up and facing the
rear of the appliance. The bottom end of Log C should rest
against the pin and touch the refractory. The bark end of
Log C should rest in the notch on Log B. See Figure 7.
LOG C IN NOTCH ON LOG B
C
LOG CONTACTS PIN & REFRACTORY
Figure 7. Log C Installed
4. (LOG D): Locate the pins for Log D in Figure 4. Place
Log D in the appliance with the burned out area of that log
facing the front of the appliance, as shown in Figure 8. The
right side of the log should contact Pin 1, and the left side
of the log should rest in the notch on Log B. Log D should
contact the back refractory. Log Pin 2 should help stabilize
Log D in the event that it would tip forward.
LOG D IN NOTCH ON LOG B
LOG D CONTACTS BACK REFRACTORY
D
C
A
Figure 8. Log D Installed
B
A
LOG D CONTACTS
LOG PIN 1
B
57
Advertisement
Table of Contents
