Table of Contents
Advertisement
5. (LOG E1): Locate the pins for Log E1 in Figure 4.
Place Log E1 in appliance with the burned out area of
the log facing the front of the appliance as shown in
Figure 9. The right side of the log should contact Pin
1, and the left side of the log should rest in the notch
on Log B. Log E1 should contact the back refractory.
Log Pin 2 should help stabilize Log E1 in the event it
would tip forward.
LOG E1 PLACED IN NOTCH ON LOG B
LOG CONTACTS BACK REFRACTORY
E1
C1
LOG E1 CONTACTS LOG PIN 1
D
A
Figure 9. Log E1 Installed
6. (LOG F): Locate the pin for Log F in Figure 4. Place
Log F into the appliance as shown in Figure 10 with
the burned out area facing the front of the appliance.
The right side of the log will rest against the log pin and
the left side will rest on top of Log E1. The log should
contact the back refractory.
LOG F RESTS ON LOG E1
LOG CONTACTS REFRACTORY
E1
LOG CONTACTS LOG PIN
A
Figure 10. Log E Installed
Majestic • DBDV36PLATIN, DBDV36PLATIL, DBDV42PLATIN, DBDV42PLATIL Installation Manual • 2454-980 Rev. F • 5/17
B
F
7. (LOG G): Place Log G into appliance as shown in
Figure 11. The narrow end of the log contacts the back
refractory and the right side contacts Log F. The front
of Log G rests in the notch of Log A. Log G should be
positioned to the left side of the notch in Log A.
LOG CONTACTS BACK REFRACTORY
E1
LOG CONTACTS LOG F
D
B
A
LOG E2 CONTACTS LOG F
Figure 11. Log E2 Installed
8. (LOG C2): Place Log C2 into the appliance as shown
in Figure 12. The notch on the bottom of Log C2 should
rest on the horizontal grate tine, approximately halfway
between the middle and right grate tines. The top of
Log C2 rests in the notch of Log A. It will be spaced
almost equally between Logs B and G.
ALMOST EQUAL SPACES
E1
D
C2
B
A
NOTCH ON HORIZONTAL GRATE TINE
Figure 12. Log C2 Installed
F
G
SLIDE LOG TO LEFT
SIDE OF NOTCH IN
LOG A
F
G
61
Advertisement
Table of Contents
