Epson EPL-N7000 Reference Manual page 147

When multiple copies are selected for printout, turn the Collate
function on in the printer driver setting. When you print out by
using the printer's control panel, first specify the necessary number
of copies on the control panel, and then start the print job.
The Reserve Job function cannot be used when you are printing by
using the AppleTalk protocol in Windows NT4.0/2000. When you
are using the AppleTalk protocol, do not use the Reserve Job
function. Use any protocol other than the AppleTalk protocol when
using the Reserve Job function.
Make sure to clear the Job Management On check box on the Job
Settings sheet when outputting data as a PS file. The Job
Management check box is selected by default so that the job
information is attached to the print data when it is sent to the printer.
Using the Reserve Job function
Settings for the Reserve Job function are carried out in the
PostScript printer driver. Follow the instructions below to specify
Reserve Job function settings:
Note:
The Reserve Job function can be used only when the printer is equipped
with the optional Hard Disk Drive. The Hard Disk Option setting must
be set to Installed in the PostScript printer driver in order to use the
Reserve Job function in Windows NT4.0/2000/XP. Before using the
Reserve Job function, make sure that the Hard Disk setting is set to
Installed in the Device Options sheet in the printer driver or under the
Installable Option setting in the Device Settings sheet. This setting does
not appear in Windows 95/98/Me.
Follow these steps to use the Reserve Job function when printing
from any application:
1. Click Print under the application's File menu.
2. Click the Properties button, and then click the Job Settings tab.
136
Using the PostScript Printer Driver (Windows)