England's Stove Works 50-SNC30 Installation & Operation Manual page 6

WHY THE CORRECT FLUE SIZE IS IMPORTANT: 6"
"Draft" is the force that moves air from the appliance up through the chimney. The amount of draft in
your chimney depends on the length of the chimney, local geography, nearby obstructions, and other
factors. Too much draft may cause excessive temperatures in the appliance. An uncontrolled burn or
a glowing red part or chimney connector can indicate excessive draft. Inadequate draft may cause
back puffing into the room and "plugging" of the chimney and/or cause the appliance to leak smoke
into the room through appliance and chimney connector joints.
Today's solid fuel appliances are much more efficient than in the past. The units are designed to give
you controlled combustion, as well as maximum heat transfer, using less fuel to do so.
The design of your new appliance is such that the exhaust "smoke" is now at lower temperatures than
in the past, therefore requiring proper chimney size to give adequate draft. If your chimney is too
large, the heater will have a difficult time raising the temperature of the flue enough to provide
adequate draft, which can cause a "smoke back," poor burn, or both.
Should you experience such problems, call in a local chimney expert.
With the door closed, the rate of burning is regulated by the amount of air allowed to enter the unit
through the air control. With experience, you will be able to set the control for heat and burning time
desired.
Attempts to achieve higher output rates that exceed heater design specifications can result in
permanent damage to the heater. The recommended wood load is level with the top of the firebricks.
Overloading may prevent sufficient air entering the heater to properly fuel the fire.
Do not tamper with the combustion air control beyond the normal adjustment capacity.
Operate this heater only with the door closed.
DO NOT OVERFIRE. If the heater or chimney connector glows, you are overfiring.
ALWAYS PROVIDE A SOURCE OF FRESH AIR INTO THE ROOM WHERE THE UNIT IS
INSTALLED. FAILURE TO DO SO MAY RESULT IN AIR STARVATION OF OTHER FUEL
BURNING APPLIANCES AND THE POSSIBLE DEVELOPMENT OF HAZARDOUS CONDITIONS.
THIS HEATER IS EXTREMELY HOT WHILE IN OPERATION. SERIOUS BURNS CAN RESULT
FROM CONTACT. CAUTION SHOULD BE OBSERVED, ESPECIALLY WHEN CHILDREN ARE
PRESENT.
CANADA Clearance to Combustibles (See Illustration 1) – see p. 7 for USA
Appliance Clearances
No stove heat shields
Side and Rear shields, single
wall chimney connector
Side and Rear shields, double
wall connector
NOTE: Flue Connector to back wall (C):
NOTE: Flue Connector to corner (E):
**Please Note that the AC-16 blower requires approx. 7" if installed on the rear of the unit
CLEARANCE TO COMBUSTIBLES (See Illustration 1)
Unprotected Surfaces
Side (A) Rear (B) Corner (D)
20-in 14-in
21-in 8-in
20-in 5-in**
1. Single wall connector with rear shield = 18"
2. Single wall connector with rear & side shields = 10"
3. Double wall connector with rear & side shields = 7"
1. Single wall connector with rear shield = 20.5"
2. Single wall connector with rear & side shields = 19.5"
6
Protected Surfaces (NFPA-211)
Side (A) Rear (B)
15-in 12-in 12-in
15-in N/A N/A
15-in 12-in 5-in**
Corner (D)
12-in
N/A
12-in