Table of Contents
Advertisement
T7200
INSTRUCTIONS
On/Off Setting: Press
Mode Selection: Press M to change the working mode,
Temperature Setting: Press either
Fan Speed Adjustment: Press
Delay On/Off setup: Press and hold
then press
or
to adjust the minute by 30 minutes.
Note: Time-On/Off setting performs only once within one day.
Delay On/Off Cancel: Press and hold
Off delay time, then press
Lock setup: If Lock function is enabled, the thermostat locks automatically after 30 seconds unused.
Unlock function: Press and hold the
seconds unused.
Tio2/ESP Manual: When Tio2/ESP function is set to Manual, press
PARAMETER SETTING (PART 1/2)
button for 5 seconds at power off mode to get in parameter list. Press M button to scroll the list and use
Press
and
parameter value.
T7200-
T7200-
TB21-9JS0,
TF20-9JS0,
T7200-
T7200-
Code
TB21-9JS1
TF20-9JS1
■
■
01
■
■
02
■
■
03
■
■
04
■
■
05
■
■
06
■
■
07
■
■
08
■
■
1
09
■
2
10
---
■
2
11
---
■
2
12
---
■
■
13
■
■
14
...Continued...
P/N 24-85784-00186 Rev. C Issue Date: 01 2020
to turn on, press again to turn off, close the fan and valve.
or
button to increase or decrease the temperature by 0.5°C.
to switch the fan mode, auto
button 5 seconds, then "ON" appears, press
button 5 seconds, then "ON" appears, press
or
adjust the time to "00:00".
button for 5 seconds to unlock. The thermostat locks automatically after 30
Parameter Name
Upper setpoint limit
Lower setpoint limit
Application
Cooling setpoint unoccupied
Heating setpoint unoccupied
Frost protection
Frost protection setpoint
Fan speed in AUTO mode in
deadband (room temperature
reach set point)
Fan mode when unoccupied
ECM Min voltage
ECM Max voltage
ECM cut off relay (F-ON)
Restart after power failure
Keypad lock
for cooling,
for heating, and
flash, high
, medium
button once, to switch Tio2/ESP On or Off.
Default
Function
35°C
Setting range 2°C to 40°C (36°F to 99°F)
5°C
Setting range 0°C to 38°C (32°F to 95°F)
T7200-TB21-9JS0, T7200-TB21-9JS1
00: 2-pipe ON/OFF valve with EC Motor Control
01: 4-pipe ON/OFF valve with EC Motor Control
02: 2-pipe ON/OFF three wire relay valve with EC Motor Control
03: 2-pipe ON/OFF valve with TiO2/ESP relay with EC Motor Control
04: 2-pipe ON/OFF valve with floor heating with EC Motor Control
05: Water source heat pump with EC Motor Control
06: Single fan speed AHU
00
07: 2-pipe Proportional valve, three speed fan
T7200-TF20-9JS0, T7200-TF20-9JS1
00: 2-pipe ON/OFF valve
01: 4-pipe ON/OFF Valve
02: 2-pipe ON/OFF three-wire relay valve
03: 2-pipe ON/OFF valve with TiO2/ESP relay
04: 2-pipe ON/OFF valve with floor heating
05: Water source heat pump
26°C
Setting range 22°C to 32°C (72°F to 90°F)
18°C
Setting range 10°C to 21°C (50°F to 70°F)
00: On
00
01: Off
5°C
Setting range 0°C to 20°C (32 °Fto 68°F)
00: Fan off
01
01: Low speed
00: Low speed
00
01: Set speed
3V
Min voltage below which the fan output is 0%, range 0 V -10 V. (0.5 V)
10V
Max voltage above which the fan output is 100%, range 0-10 V
00: Disabled
00
01: Enabled
00: Keep last status
01: On
00
02: Off
00: No lock
01: Lock all keys
02: Lock the keys except Fan Speed and Temp Adjustment keys
00
03: Lock the ON/OFF and Timer keys
04: Lock the keys except ON/OFF key
English
for venting.
, low
fan.
button to switch On or Off delay,
button to switch to check On or
and
button to change
Hide quick links:
Advertisement
Table of Contents
