Port Designations In Webview - Enterasys Matrix E1 1H582-51 Software Manual

2.6

PORT DESIGNATIONS IN WEBVIEW

The expansion module and fixed front panel port numbering scheme used when configuring
Matrix E1 ports is shown in
Ethernet connections. In WebView screens with Port listings, these fixed front panel ports are
designated as 1 through 48.
The device's optional expansion module slots (1, 2, and 3), can have two to 16 ports depending on
the module installed.
this printing, and the location of the next consecutive port on each module.
numbering scheme for the fixed front panel, and for each expansion module installed in various
slots, as it would appear in WebView screens with Port listings.
NOTE: The WebView port numbering scheme is based on the fact that each optional
expansion module can have up to 16 ports. Therefore, designations for expansion
modules with only two ports span all 16 numbers in the numbering sequence to allow for
the possibility that the 2-port module could be exchanged with a 16-port module.
For information on how this device's port assignment scheme is expressed in CLI syntax, and
considerations necessary for configuring port mirroring and trunking, refer to your Matrix E1
Series Configuration Guide.
Figure 2-3. Fixed front panel ports 1 through 48 are RJ45 10/100
Figure 2-4 shows the Ethernet Expansion Modules available at the time of
Port Designations in WebView
Table 2-2
Starting and Navigating WebView
shows the
2-7