Removing An Iom; Installing An Iom (G3G-24Tx With Optional Poe Shown) - Enterasys G3G124-24 Hardware Installation Manual

Figure 2-4
1 IOM slot 2
2 IOM handle
3 Captive screw
7. To install additional modules, remove the coverplates from the slots and repeat earlier steps.
Save coverplates for optional future use.
8. After completing all module installation, be sure to install coverplate(s) over any unused IOM
slot(s) to contain EMI radiation and ensure proper air circulation.
Note: You must reboot the system before hot-inserted IOM modules will be recognized. Once
rebooted, module LEDs will display as described in

Removing an IOM

Caution: Do not attempt to remove an IOM module from the G-Series switch when power is on to
the switch without performing the following procedure.
Precaución: No intente retirar el módulo IOM del switch G Series si éste está encendido. Antes de
hacerlo, debe realizar el siguiente procedimiento.
To remove an installed IOM, first disconnect any cabling and perform these steps:
1. Loosen the module's two captive screws.
2. Press the POWER OFF button corresponding to the slot from which you want to remove the
IOM. Refer to Figure
3. When the slot's POWER OFF status LED turns amber, gently slide the module out of the slot.
For more information, refer to "IOM Status LEDs" on page 3‐3

Installing an IOM (G3G-24TX with optional PoE shown)

3‐1 on page 3‐2 for more information.
4 Optional PoE module
5 IOM module
"IOM Status LEDs" on page 3-3.
.
Enterasys G-Series Hardware Installation Guide 2-11
Installing and Removing an IOM