This guide provides an overview, specifications and instructions for installing the Enterasys®
G‐Series Ethernet Switch in a standard 19‐inch equipment rack, or on a suitable flat surface. This
guide also explains how to interpret the system status LEDs to facilitate troubleshooting when
necessary, and also provides information on how to contact Enterasys Networks for additional
help.
Who Should Use This Guide
This guide is intended for a network administrator who is responsible for installing and setting up
the G‐Series switch.
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents and to gain an
understanding of the features and capabilities of the G‐Series switch. A general working
knowledge of data communications networks is helpful.
For information about...
An overview of the G-Series chassis
Instructions to install the G-Series chassis hardware
Troubleshooting installation problems and diagnosing
network/operational problems
Specifications, environmental requirements, and physical
properties of the G-Series.
Related Documents
To configure the G‐Series switch, refer to the Enterasys G‐Series Configuration Guide.
Manuals can be accessed on the World Wide Web, using the following URL:
http://www.enterasys.com/support/manuals/
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Electrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
About This Guide
Refer to...
Chapter 1,
Introduction
Chapter 2,
Installation
Chapter 3,
Troubleshooting
Appendix A,
Specifications
Enterasys G-Series Hardware Installation Guide xiii