Mgbic-08 Specifications (1000Base-Elx; Mgbic-Lc09 Specifications (1000Base-Lx; 10-Gigabit Ethernet Transceiver (Xfp) Specifications; Mgbic-08 Optical Specifications - Enterasys G3G124-24 Hardware Installation Manual

MGBIC-08 Specifications (1000BASE-ELX)

Table A-18 MGBIC-08 Optical Specifications
Item
Transmit Power (minimum)
Receive Sensitivity
Maximum Input Power
Link Power Budget
(Full Duplex Only)
1. The maximum drive distance (up to 80 km) depends on the quality of the installed single-mode fiber-optic
cable segment. Use the Link Power Budget to calculate the maximum cable length of the attached segment.
The Link Power Budget must not exceed those specified in this table. The MGBIC-08 input power must not
exceed -3 dBm. Otherwise, saturation could occur.
Table A-19 MGBIC-08 Operating Range
Item
9 or 10 µm SMF

MGBIC-LC09 Specifications (1000BASE-LX)

Table A-20 MGBIC-LC09 Optical Specifications
Item
Transmit Power (minimum)
Receive Sensitivity
Link Power Budget
Table A-21 MGBIC-LC09 Operating Range
Item
62.5 µm MMF
50 µm MMF
50 µm MMF
10 µm SMF

10-Gigabit Ethernet Transceiver (XFP) Specifications

The 10‐Gigabit Small Form Factor Pluggable (XFP) interface port slots on the G3 modules support
various optional 10‐Gigabit Ethernet (10 GbE) standard type fiber‐optic transceivers. Table
provides the input/output specifications for each supported XFP version as specified in the IEEE
802.3ae‐2002 standard.
-0 dBm, min.
-24 dBm, min.
-3 dBm
1
23 dB
1550 nm
N/A
62.5 µm MMF
-11.5 dBm
-20 dBm
8.5 dBm
Modal Bandwidth @ 1300 nm
500 MHz/km
400 MHz/km
500 MHz/km
N/A
10-Gigabit Ethernet Transceiver (XFP) Specifications
+2 dBm, typical
-26 dBm, typical
28 dB, typical
Range
80,000 Meters
50 µm MMF 10 µm SMF
-11.5 dBm -9.5 dBm
-20 dBm -20 dBm
8.5 dBm 10.5 dBm
Range
2-550 Meters
2-550 Meters
2-550 Meters
2-10,000 Meters
Enterasys G-Series Hardware Installation Guide A-9
+5 dBm, max.
A‐22