Connecting The K-Poe-4Bay Poe Shelf To A K-Series Chassis; Removing The Cover From The Poe Connector On A K-Series Chassis; Contents Of K-Series Ac Power Supply Carton - Enterasys K-Series Installation Manual

Connecting the K-POE-4BAY PoE Shelf to a K-Series Chassis

Table 3-1 Contents of K-Series AC Power Supply Carton
Item
K-Series AC power supply
For USA shipments: NEMA power cord 5-15,C13
Type of power cord is dependent on country of installation.
WEEE notice card
Documentation notice card
Connecting the K-POE-4BAY PoE Shelf to a K-Series Chassis
Use a K-POE-CBL-2M cable to connect a K-Series AC power supply installed in a K-POE-4BAY
PoE shelf to a K-Series chassis.
You can connect up to two K-Series AC power supplies to a K10 chassis for PoE power. You can
connect a single K-Series AC power supply to a K6 chassis for PoE power.
To connect a K-Series AC power supply to a K-Series chassis for PoE power:
1. Remove the cover from the recessed PoE connector at the rear of the K-Series chassis. See
Figure
If you are connecting two power supplies to a K10 chassis, remove the covers from both PoE
connectors.
Figure 3-1
3-2 Installing a Power Supply
Note: You must purchase the K-POE-CBL-2M cable separately. Ensure that you purchase and
install one K-POE-CBL-2M cable for each power supply that you plan to install in the K-POE-4BAY
PoE shelf.
3-1.

Removing the Cover from the PoE Connector on a K-Series Chassis

Quantity
1
1
1
1