Installing and Removing an IOM
Installing an Optional PoE Module on the G3G-24TX
If you have purchased an optional PoE card (G3G‐POE), you can install it before installing the
G3G‐24TX IOM into the G‐Series base system chassis. You can also install it at any time by first
removing the IOM module as described in "Removing an IOM" on page 2‐11.
The G‐Series PoE card and IOM module will be shipped in separate packages. Unpack and install
the PoE card in the IOM as follows:
1.
With an ESD strap attached to your wrist, open the box and remove the packing material
protecting the PoE module.
2.
Perform a visual inspection of the PoE module for any signs of physical damage. Contact
Enterasys Networks if there are any signs of damage. Refer to "Getting Help" on page xv for
details.
3.
Gently plug the PoE module into the IOM by fitting the standoffs into the PoE board
mounting holes as shown in Figure
standoffs to PoE mounting holes.
Caution: There are hazardous moving parts inside the base unit. Keep fingers and other body
parts away from spinning fans when installing or removing IO modules.
Precaución: El interior de la unidad que sirve de base contiene partes móviles peligrosas.
Mantenga los dedos y cualquier otra parte del cuerpo lejos de las aspas de los ventiladores cuando
realice la instalación o al retirar los módulos IO.
Notes: Instructions in this section do not fully describe installing PoE on the G3G124-24 base
system, which requires completing several disassembly steps first. For more information on base
system assembly, refer to
page 2-21.
The instructions below apply only to the G3G-24TX IOM module.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
"Installing an Optional PoE Module in the G3G124-24
2‐3. There should be a direct vertical translation of
Installing and Removing an IOM
Enterasys G-Series Hardware Installation Guide 2-9
Switch" on