Table of Contents
Advertisement
This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys
10‐Gigabit Ethernet uplinks.
For information about the Command Line Interface (CLI) set of commands used to
configure and manage the switch, refer to the Enterasys Networks
Configuration Guide.
Depending on the firmware version used in the C2K122-24 switch, some features described in this
document may not be supported. Refer to the Release Notes shipped with the switch to determine
which features are supported.
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting
up the stackable switch.
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents to gain an
understanding of the features and capabilities of the stackable switch. A general
knowledge of data communications networks is helpful when setting up the switch.
Note: In this guide, the following terms are used:
• Switch refers to a C2K122-24,
• XSP refers to optional small-form pluggable interface modules that plug into the front
panel port slots 25 and 26.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
About This Guide
®
SecureStack C2K122‐24 stackable Gigabit switch with
unless otherwise noted.
Important Notice
®
SecureStack C2
SecureStack C2 Installation Guide xv
Advertisement
Table of Contents
Troubleshooting
